What a renewed bath helps you avoid
No full strip-out
You keep a sound bath in place and avoid the extra mess that replacement can bring.
Matched to the damage
We advise on full resurfacing or a smaller repair, depending on what the bath needs.
Clear price from the start
Quotes reflect condition and preparation, so you're not guessing what the work involves.
When a full bath resurface makes sense
A bath can still be solid and worth keeping even when the finish looks past its best. Staining, dull patches, heavy wear and old marks can make the whole room feel grubby, even after a proper clean. Full resurfacing is the answer when the problem is spread across the bath rather than sitting in one small spot. In Edinburgh, we inspect the surface first, check the substrate, look at any earlier coatings and decide whether a full re-enamel is the sensible route. Done on a sound bath, it gives you a fresh, cleaner-looking finish without the mess of pulling the fixture out and disturbing tiles, panels or plumbing.
Careful preparation shapes the final finish
Good results start long before the coating goes on. We clean and prepare the bath, deal with defects that would spoil the surface, mask nearby fittings and only then apply the new finish. If the damage is limited to one chip or crack, we may suggest a local repair instead of treating the whole bath. Once the coating is complete, we explain curing times and aftercare so you know when the bath can go back into use and how to keep the renewed surface looking right.
